Grand Prairie Pool Pros provides professional pool lighting & led retrofits in Grand Prairie, TX for residential and commercial properties across the DFW Metroplex. Swapping a pool light for LED takes an afternoon, drops roughly 500 watts down to about 40, and lasts around 30,000 hours instead of a couple of seasons. If your current light hums, eats bulbs, and turns the water a sort of nicotine yellow, you're running 1980s technology and paying a monthly fee for the privilege.
The retrofit is simpler than most people fear. Modern LED units are built to drop into standard wet niches, so we kill the circuit, pull the old fixture out on its cord, feed the new cord back through the conduit, set the fixture and refill.
No deck cutting, no digging, and in most cases no full drain.
Color-changing units run a set of fixed shows and solid colors, controlled either from the breaker or, much better, from an automation panel that can hold a color without you flicking a switch five times to find it.
Where it gets more interesting is nicheless LED. Those need only a small wall penetration, which means we can add light to a pool built in 1989 with one badly aimed fixture at the deep end. Two smaller lights beat one bright one every time.
A single fixture gives you a hot spot and a lot of glare. A pair placed to cross-light gives you even water and lets you actually see the bottom, which is a safety point as much as a design one.
Spa lights, step lights and lit bubblers are cheap to add while everything is already open.
Electrical is the part we won't be casual about. A pool light sits in water, on a circuit, next to people.
We check the bonding grid, confirm the GFCI actually trips when tested rather than merely existing, look at the junction box height, and inspect the conduit and niche for corrosion. Any fixture that has taken on water gets replaced, not dried out and reinstalled.
If we find aluminum conduit rotted at the niche or a bonding wire that was never landed, we'll tell you, because that's the kind of fault that hides for fifteen years and then doesn't.
Outside the water, low-voltage landscape and deck lighting changes how the backyard looks at night more than the pool light does. Uplighting two trees and washing a seat wall transforms the space, runs on 12 volts, and goes in without trenching a main circuit or pulling a permit.
The honest option. If your existing incandescent works, the water looks fine to you, and you mostly swim in daylight, you don't need this.
Nothing about an old fixture is unsafe as long as the bonding and the GFCI are correct, and we'd rather test those and leave than sell you a fixture.
Where the retrofit genuinely pays is on a pool whose light burns most nights, or one with a dead fixture already, because replacing a burnt-out incandescent with another incandescent is a decision you get to regret twice.
With 15+ years of experience, our licensed and insured team brings the right materials and equipment to every job — gunite and shotcrete shells, PebbleTec and polished quartz interiors, white marcite plaster, glass mosaic and porcelain waterline tile, travertine coping and decking, variable-speed pumps — and backs the work with a written workmanship warranty. We serve Grand Prairie and nearby communities including Arlington, Mansfield, Cedar Hill, Duncanville.
What We Handle
Everything our pool lighting & led retrofits in Grand Prairie covers
One crew, one point of contact, and the full range of pool lighting & led retrofits work in Grand Prairie, TX. If it is on this list we do it in house rather than handing it to a subcontractor:
- pool light replacement
- LED pool light retrofit
- color-changing LED pool and spa lights
- fiber optic to LED conversion
- nicheless LED lighting for existing pools
- 12-volt low voltage pool lighting
- landscape and deck lighting
- GFCI and bonding for pool lights
- pool light niche and conduit repair
- underwater light leak and moisture repair
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Grand Prairie services.
Materials, equipment and how we do pool lighting & led retrofits
The difference between pool lighting & led retrofits that lasts and pool lighting & led retrofits that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with gunite and shotcrete shells, PebbleTec and polished quartz interiors, white marcite plaster, glass mosaic and porcelain waterline tile, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Grand Prairie job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. 15+ years of pool work in the DFW Metroplex means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do pool lighting & led retrofits outside Grand Prairie
Grand Prairie Pool Pros covers Grand Prairie and the surrounding communities of the DFW Metroplex. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Pool Lighting & LED Retrofits in Arlington, TX — Tarrant County, population 394,000
- Pool Lighting & LED Retrofits in Mansfield, TX — Tarrant County, population 72,600
- Pool Lighting & LED Retrofits in Cedar Hill, TX — Dallas County, population 49,100
- Pool Lighting & LED Retrofits in Duncanville, TX — Dallas County, population 40,700
- Pool Lighting & LED Retrofits in DeSoto, TX — Dallas County, population 56,100
- Pool Lighting & LED Retrofits in Lancaster, TX — Dallas County, population 41,300
Start on the Grand Prairie Pool Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Grand Prairie Chooses Grand Prairie Pool Pros
- ✓Over 15 years remodeling, resurfacing and building pools across Grand Prairie and the DFW Metroplex
- ✓Specialists in bringing 1980s and 1990s pools up to date: new interiors, tile, coping, decking and equipment
- ✓Residential and commercial, from backyard gunite pools to hotel, apartment and HOA pools built to Texas code
- ✓Shells engineered for Blackland Prairie clay, and equipment specified for North Texas hard water and hard freezes
The standards behind pool lighting & led retrofits
Quality here is not a matter of opinion — it is written down. The pool lighting & led retrofits work we do in Grand Prairie follows published industry standards: Pool & Hot Tub Alliance publishes the ANSI/APSP construction and barrier standards, and American Red Cross water safety sets out the layered-protection guidance every pool owner should read. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every pool lighting & led retrofits project in Grand Prairie gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free pool lighting & led retrofits free estimate in Grand Prairie, or request a quote and we'll get right back to you.